Labels

Aileron (31) Avionics (72) Canopy (80) Cowl (28) Electrical (39) Elevators (36) Empennage (94) fiberglass (22) Firewall Forward (57) Flap (43) Fuel System (23) Fuel Tank (4) Fuselage (156) Horizontal Stabilizer (25) Interior (27) Landing gear (10) Paint Schemes (2) Parachute (30) prop (2) Rudder (13) Vertical Stabilizer (14) Wing (133) Wing tip (2) Wiring (18)

Friday, July 11, 2014

Antenna doublers, BRS harness and seat floor prep: 7 hours

This work session: finished and installed antenna doublers for comm radio and transponder, installed wire clips in the forward pushrod tunnel, drilled holes in the seats floors for headphone wiring, started fitting seat floors such as fitting around seat belt anchors.

I also worked on the some of the parachute components including installing the rear internal kevlar harness that links the bottom reinforcement plate to the top anchor and the aft parachute harness. I also did some research on locating the parachute activation handle.

Antenna doublers:

Rear parachute anchor points and kevlar harness:

Top anchor point and parachute harness:

Comm antenna doubler installed:

Pushrod tunnel wire clips:

Another shot of the comm antenna doubler:

Posted by at
Labels: ,