I got the rudder pedal support piece finished and primed.
The main task was starting on the install of the static system tubing. I ended up having to make a run to Sears to get a special cutter for the tubing. I'm using quick connect fittings for the tubing distributed by Safeair. The fittings work very well but require a very clean and straight cut on the tubing. I also used a small amount of silicone grease on the ends of the tubes as suggested by VAF forums.
I made a bracket from scrap angle to hold the T fitting. I will be making more of these to help route the tubing forward.
Off to a good start:
The big cutter on the right is the anvil cutter from Sears.
Posted with Blogsy