- Made left side tail stiffener angle and drilled to fuselage.
- Cleaned, prepped and primed / re-primed stiffeners, various small parts and some of of the horizontal stabilizer and aft fuselage.
- Installed snap bushings, pop riveted wire tie clips and routed wires in the tail section.
- Riveted stiffener mod angles in place
- Riveted upper vertical stabilizer bracket in place
Elevator trim wire going up:
New stiffeners are just below the access panel openings, also tail lighting wire in the middle:
Cleaned and primed aft fuselage deck:
A fair amount of small parts to prime:
