- Mounted fuel tank brackets - used my new 1/4" electronic torque wrench - worked great
- I wasn't happy with the washers acting as spacers for the elevators main bearing so I tried some different combinations and ended up filing one washer down to get a good fit.
- After everything was lined up I cut out a block of maple on my miter saw to act as a drill guide. I used the drill press to drill the 1/8" guide hole.
- I drilled the pilot hole then used reamers to open both holes up to 3/16" - the results look good and straight.
Ready to drill for pushrod bolt:
Fuel tank bracket permanently mounted:
