After dimpling I wiped down the parts with MEK and primed with NAPA 7220 self etching primer. Easy to use and very tough.
Primed and ready to rivet...
Next up is deburring and priming the skins. Then rivet it all together!
Construction progress and builder's log for my Van's RV-7 project N769WB
Tuesday, June 19, 2012
Dimpled horizontal stab structure and primed: 3 hours
This went well. Started out with the table dimpler but the best solution was the pneumatic squeezer mounted in a vise.
After dimpling I wiped down the parts with MEK and primed with NAPA 7220 self etching primer. Easy to use and very tough.
Next up is deburring and priming the skins. Then rivet it all together!
After dimpling I wiped down the parts with MEK and primed with NAPA 7220 self etching primer. Easy to use and very tough.
Next up is deburring and priming the skins. Then rivet it all together!
